Connect your device to load live status, change settings and save configuration updates.
RS485 module not detected — Modbus is disabled. Check that the module is installed correctly.
Hardware is not recognized as supported Smartstuff hardware. Modbus remains available, but Custom mapping cannot be activated.
Overview
Connect your Smartstuff device with a USB cable to manage status, configuration and live runtime values in one place.
Modbus monitor
The monitor is disabled in Configuration.
| Uptime | ID | FC | Address | Words | Response | Result |
|---|
Modbus statistics
Times are since boot. ID is the addressed device, not the master. OK means a response was built, not confirmed received. Only requests reaching the registered handlers are counted.
| ID | FC | Address | Words | Requests | OK | Errors | Last error | First | Last | Min gap (ms) | Max gap (ms) | Last write |
|---|
Device
| Connection status | Disconnected |
| Hardware type | – |
| Hardware module | – |
| Mac address | – |
Firmware
| Installed | – | |
| Stable | – Recommended | |
| Beta | – Beta |
Connect a device to load available firmware releases.
Wi-Fi
| Wifi status | – |
| Wifi IP address | – |
Live Status
| P1 pre40 | – |
| P1 CRC check | – |
| P1 RAW capture | – |
| P1 telegram ok | – |
| P1 telegram err | – |
| Modbus runtime | – |
| Custom mapping | – |
Configuration
| Setting | Value |
|---|